Assembling your Snow Globe shaker cards

Start your card by picking your desired design from the included die cut decoupage sheets and pop out all elements on the design. Following the number order on the sheet, assemble your 3D snowman globe scene using foam pads or silicone glue between each of the decoupage layers.

Take your display globe and add double-sided tape to both sides of the outer rim. Peel back the tape on the bottom of the rim and before sticking it down on top of your assembled design, place a small heap (less is more!) of Polar White Flower Soft® to

Next, peel back the tape on the top of the rim of your display globe and stick it down to the inside of your 5x7 aperture card behind the aperture cutout. Take one of the 5x7 insert papers and fold it in half. Place it inside your card and stick it down into place, covering up the back of your globe display.

Now it’s time to get creative and decorate! Choose from the included die-cut sentiments, double-sided 3D bows and shimmering silver peel-off stickers to bring your vision to life. Need some ideas? Take a look at these marvellous creations by our talented design team!

Assembling your Pillow Treat Boxes

Fold back the long, thin glue tab and apply adhesive. Next, following the prescored crease line in the centre of your flat treat box, fold the bottom section up to meet the glue tab and secure in place.

Now that the basic shape of your treat box is formed, you can now fold in the ends. Next, follow the prescored fold lines and, one by one, bend each end into place. Finally, cut out a topper from your included fussy-cut topper sheets and glue to your assembled box, ready for posting.

Assembling your 3D Bows

Select a small bow and pop it out of the pre-cut sheet to start. Next, take a ruler and score along both dotted lines, then fold over to form your bow shape. Make sure the knot is on top, and glue into place. You can stop here for a flat look or you can add some dimension to your bow by carefully pinching each loop with your fingers.

Select your bow and pop all three pieces out from the pre-cut sheet. To create the loops, grab piece 'A', take each outer point and bring it over towards the centre point and glue it into place as you go (make sure you don’t fold your bow flat, we want a 3D rounded look). Once formed, glue on top of piece 'B' to add the ribbon tails. Finally, add the knot by wrapping piece 'C' around the centre of your bow.